Rear Cover & Latch Assembly Replacement Procedure - GE Vivid i n Service Manual

Hide thumbs Also See for Vivid i n:

Table of Contents

Rear Cover & Latch Assembly Replacement Procedure

This section describes the replacement procedure for Rear Cover & Latch Assembly - supplied as part

of the Cover Kit (Vivid i n systems Part No. S2423361; Vivid q N systems Part No. S2423362).

None required.

Time Required

Preparations

Shut down the Vivid i n/ Vivid q N ultrasound unit, as described in - System Setup.

Rear Cover & Latch Assembly Removal Procedure

1) Disconnect the AC adapter and all cables from the Vivid i n/Vivid q N portable ultrasound scanner.

2) Remove the Bearing Handle as described in the

3) Remove the Control Panel and Keyboard as described in the

Procedure on page 8 -

4) Remove the LCD Display Frame as described in the

5) Remove the LCD Display; see the

6.) Loosen and remove the two screws on each of the left and right hinges (attached to the Rear Cover

and Latch Assembly), as shown in

7.) Lift the Rear Cover and Latch Assembly away from the Bottom Assembly and remove completely

from the system.

Rear Cover & Latch Assembly Installation Procedure

1.) Return the Rear Cover and Latch Assembly to the system and place it in position on the Bottom

Assembly, carefully checking that the left and right hinges are properly aligned.

2.) Return and fasten the two screws on each of the left and right hinges (previously removed - refer

3) Return the LCD Display; see the

4) Return the LCD Display Frame as described in the

Figure 8-23 Removing the Hinge Screws

Chapter 8 - Replacement Procedures

Bearing Handle Removal Procedure on page 8 -

LCD Display Frame Removal Procedure on

LCD Display Removal Procedure on page 8 -

LCD Display Installation Procedure on page 8 -

LCD Display Frame Installation Procedure on

IVID I N AND

Control Panel and Keyboard Removal