Breville Aroma Style Electronic LCM700 Instruction Book page 9

2. Press the 'HOUR' button to select the
current hour time. Press and hold the
'HOUR' button to scroll through numbers
quickly. When the number displayed
approaches the desired setting, press and
release the button to advance one digit at
a time. (AM is indicated in the upper left
hand corner of the clock display and PM in
the lower left hand corner).
3. Press the 'MINUTE' button to select
the current minute time. Press and hold
the 'MINUTE' button to scroll through
numbers quickly. When the number
displayed approaches the desired setting,
release and press the button to advance one
digit at a time.
The Clock is now set.
BREWING COFFEE
MANUAL OPERATION
1. Lift the water tank lid and fill the water
tank with cold water. The number of cups
is shown by the water level indicator. Do
not exceed the maximum fill level. It is
recommended not to make less than 4 cups.
NOTE
There are two drain holes on the back of the
water tank to prevent exceeding the capacity of
the coffee maker. If too much water is added it
will flow from these holes down the back of the
coffee maker.
2. Insert the plug into a 230/240V power
outlet and then switch on at the outlet.
3. Ensure the filter holder is firmly positioned
into place. Insert the stainless steel mesh
filter basket into the filter holder.
NOTE
If disposable paper filters are used, insert into
the filter holder instead of the stainless steel
mesh filter basket.
4. Spoon ground coffee into the stainless steel
mesh filter basket. Allow approximately
1 heaped teaspoon of ground coffee for
each cup of brewed coffee. Close the water
tank lid.
5. Position the empty carafe, with the lid closed,
onto the hot plate.
6. Press the ON/OFF button to switch the
coffee maker on. The light beside the ON/
OFF button will illuminate red and the coffee
will start to drip through
Strength Control
To adjust the coffee strength stronger, press the
'STRENGTH' button once before pressing the
ON/OFF button, the 'STRENGTH' indicator
will illuminate in orange and the coffee maker
will brew stronger coffee. If you do not want
to adjust the coffee strength, do not press the
'STRENGTH' button.
IMPORTANT
While the non-drip valve feature is a convenient
way to pour a cup of coffee mid-cycle, we
recommend you wait until the completion of
the brew cycle as the strength and flavour of
the coffee poured mid-cycle will vary from
the finished brew. While removing the carafe
mid-cycle will temporarily stop the coffee from
dripping into the carafe, it does not stop the
brewing cycle. After pouring a cup of coffee, the
carafe should immediately be returned to the
hot plate for completion of the brewing cycle
and to prevent the filter basket from overflowing.
7. The non-drip valve feature allows you to
interrupt the brewing cycle to pour a cup
before the entire carafe has finished filling.
8. When the brewing process ends and the
water tank level indicator is on empty, there
will still be hot liquid in the filter basket.
Wait a few minutes for the remaining liquid
to drip through into the carafe. The coffee is
now ready to be consumed..
9. After the coffee grounds have cooled, open
the water tank lid and carefully lift the mesh
filter basket by the hand up and away from
the filter holder to remove.
9