Table of Contents
Advertisement
Technical Information
2
Conversion of air-conditioning control panel
2.1
2.2
2.3
2.4
2.5
3
Remove A-pillar at the right.
3.1
Route wire harness for heating/air-condi-
tioning control panel
2.1from the instal-
lation opening
2.1in the dashboard to
the installation slot
2.1 -C -in the center
console and secure it.
Pull insert sleeves off old trim for heating/air-
conditioning control panel and insert them
into the heating/air-conditioning control panel
2.2.
Insert connector into heating/air-conditioning
control panel.
Insert heating/air-conditioning control panel
2.2 into the lower installation slot of the
center console and secure with screws
-C - .
NOTE: Use new screws (Torx 4 x 20, see
parts list).
Insert rear retaining bar
2.2 for PCM2 and
secure with screws
On all vehicles without M440, route adapter
cable from antenna
Figure 7 -2- to PCCM
Plus radio slot.
Disconnect windscreen antenna from the
antenna amplifier
Figure 7 -2-. Connect
Figure 7 -5- windscreen antenna to adapter
cable
Figure 2 -10-.
Loosen screw
Figure 7 -3- and install
ground line
Figure 7 -4-. Tighten the screw
again.
AfterSales
911 (996)
56/20
2.2
9
9112
ENU
2.1
2.2
Figure 7
Aug 31, 2020
Page 5 of 12
Hide quick links:
Advertisement
Table of Contents
