Washers; Wipers And Washers - Troubleshooting - Ford F-150 2021 Supplemental Owner's Manual

2. Lift the wiper blade primary locking clip.
E327598
3. Press the wiper blade secondary
locking clip.
4. Remove the wiper blade.
Note: Make sure that the wiper arm does
not spring back against the glass when the
wiper blade is not attached.
5. To install, reverse the removal
procedure.
Note: Make sure that the wiper blade locks
into place.

WASHERS

Washer Precautions
WARNING: If you operate your
vehicle in temperatures below 41.0°F
(5°C), use washer fluid with antifreeze
protection. Failure to use washer fluid
with antifreeze protection in cold
weather could result in impaired
windshield vision and increase the risk
of injury or accident.
Do not operate the washers when the
washer reservoir is empty. This could cause
the washer pump to overheat.
F-150 (TFD) Canada/United States of America, enUSA, Edition date: 202008, First-Printing
Wipers and Washers
Keep the outside of the windshield clean.
The rain sensor is very sensitive and the
wipers may operate if dirt, mist or insects
hit the windshield.
Using the Windshield Washer
E311291
Note: A courtesy wipe occurs a short time
after the wipers stop to clear any remaining
washer fluid when switched on.
WIPERS AND WASHERS –
TROUBLESHOOTING
Wipers and Washers – Frequently
Asked Questions
Why are there streaks and smears on
the windshield?
40
Press and hold the button at the
end of the lever to operate the
E270967
windshield washer.
The wiper blades could be dirty, worn
or damaged. Check the wiper blades.
If the wiper blades are dirty, clean
them with washer fluid or water
applied with a soft sponge or cloth. If
the wiper blades are worn or damaged,
install new ones.