Eliminating The Normal Arm/Disarm Chirps; Remote Panic Operation - Audiovox Pursuit PRO-9600 Owner's Manual

3. As soon as the chirp that corresponds to your first digit sounds, quickly turn the ignition
key;
a) Off then on if your second digit is 1
b) Off then on, then off, then on if your second digit is 2.
c) Off then on, off then on, off then on, if your second digit is 3.
4. The alarm will stop sounding, and you can now start and operate your vehicle normally.
IMPORTANT NOTICE! If you elected not to program your personal manual override code,
the factory preset code is 1:1. To override the system with the factory default code (1:1) still
in memory;
1. Open the door the alarm will sound.
2. Turn the ignition key to the on position. The alarm will stop sounding for three seconds,
then the siren will begin counting with long chirps.
3. As soon as the first long chirp is head, quickly turn the ignition key Off then on
4. The alarm will stop sounding, indicating that the system is disarmed. You can now start
and operate your vehicle normally.

ELIMINATING THE NORMAL ARM/DISARM CHIRPS:

You can selectively eliminate the normal arm & disarm chirps by holding the transmitter
button slightly longer when arming and disarming. This will prevent the siren chirps for one
arm or disarm cycle. If you find this inconvenient and wish to eliminate these chirps perma-
nently.
1. Start with the valet switch in the off position.
2. Turn the ignition switch on then off.
3. Within 10 seconds of turning off the ignition, flip the valet switch on, off, on, off, on, off.
4. If the chirps were on before you started, the siren will emit 2 short chirps indicating that the
chirps are now off. If the chirps were off before you started, the siren will emit one short
chirp indicating that the chirps are now on.
NOTE: Whenever the chirps are bypassed, the 4 chirp intrusion and the 3 chirp defective
zone indicators will continue to operate. Since these are important warnings to you that
something has happened, they cannot be eliminated.

REMOTE PANIC OPERATION:

The Arm/Disarm button of your transmitter also functions as a panic switch for use in emer-
gency situations.
To use the panic feature:
1. Press and hold the Arm/Disarm button of your keychain transmitter for 3 or more seconds.
The alarm will immediately sound.
2. To stop the siren from sounding, press and release the Arm/Disarm button of the keychain
transmitter. If the transmitter is not used to cancel the panic mode, the unit will automati-
cally stop sounding after 30 seconds.
NOTE: All alarm and transmitter functions will operate while in the panic mode.
ADDITIONAL REMOTE CHANNELS AVAILABLE FROM YOUR TRANSMITTER OR BY
PAGING THE VEHICLE:
The PRO-9600 security system has additional features that can be controlled from your
keychain transmitter as well from the satellite paging network. These features can be config-
ured to operate from a single transmitter button or from a combination of transmitter buttons.
6