Protection While The System Is Armed; Disarming The System - Audiovox Pursuit PRO-9600 Owner's Manual

Audiovox pro9600 car alarms: owners manual pursuit series
Hide thumbs Also See for Pursuit PRO-9600:
Table of Contents

Advertisement

point is opened during the 30 second arming cycle, arming will be suspended. When all
entry points are closed, the arming cycle will begin again.
At the end of the 30 seconds, The parking lights will flash once, the siren will chirp once, and
the dash mounted LED will begin to flash slowly confirming the system is armed. If the siren
did not sound when arming, then the chirps have been turned off. Refer to the section on
"Eliminating the Arm/Disarm Chirps" shown later in this manual. Passive door locking is a
selectable feature. If you have the optional door lock/unlock circuit installed, the doors may
or may not lock passively dependent upon the setup during installation.

PROTECTION WHILE THE SYSTEM IS ARMED:

Opening any protected entry point, hood, trunk, or doors will cause the alarm to trigger
immediately. The siren will sound and the parking lights will flash for 30 seconds, then stop
and continue to monitor all protected entry points. If the thief left the door opened, the unit
will sound for six 30 second cycles then shut down, ignore the triggered zone and continue
to protect all other zones.
Whenever the system is armed, the dash mounted LED will slowly flash. This serves as a
visual deterrent to a potential thief. This LED is a very low current light emitting diode, and
will not cause he battery to drain even if left unattended for long periods of time.
Whenever the system is triggered, the vehicle parking lights will flash for the full siren sounding
period. As an option, whenever the system is triggered, the interior courtesy light will flash
for the full siren sounding period.
Whenever the system is armed, the vehicle starter circuit is disabled; the ignition key will not
allow the vehicle to start.
Whenever the system is armed, any strong impact to the vehicle will cause the shock detec-
tor to trigger the alarm. Any lesser impact will cause the pre-detect stage of the shock
sensor to emit a few short series of warning tones from the siren.

DISARMING THE SYSTEM:

As you approach the vehicle, press and release the ARM/DISARM button on the keychain
transmitter.
The parking lights will flash two times, the siren will chirp twice, and dash mounted LED will
turn off.
If you have the optional door lock/unlock circuit installed, the doors will unlock. If you have
the optional entry illumination circuit installed, the interior light will turn on for 30 seconds or
until the ignition key is switched on.
Note: If the passive arming mode was selected at time of installation, the dash mounted
LED will start flashing rapidly indicating that the system is rearming. Opening any door will
suspend the automatic arming.
If the parking lights flashed three times, and the siren chirps four times, this indicates that
the alarm system had been triggered during your absence. Before turning on the ignition
key, examine the dash mounted LED's flash pattern. The number of flashes identifies the
triggered zone. For additional information, refer to INTRUSION WARNING SIGNALS found
later in this manual.
If the siren did not sound upon disarm, then the chirps have been turned off. Refer to the
section titled ELIMINATING THE ARM/DISARM CHIRPS.
3

Advertisement

Table of Contents
loading

Table of Contents