Advertisement
Quick Links
Remote Vehicle Control System
CA-520A
Owner's Manual
Remote Vehicle Starter with
Keyless Entry
IMPORTANT NOTE: The operation of the Security and Convenience System as
described in this manual is applicable to most vehicles. However, due to the
configuration of some vehicles, some functions AND/OR SAFETY PRECAUTIONS may
not apply. Please see your installing dealer for more information.
128-
1 of 6
Advertisement
Related Manuals for Code Alarm CA-520A
Summary of Contents for Code Alarm CA-520A
- Page 1 Remote Vehicle Control System CA-520A Owner's Manual Remote Vehicle Starter with Keyless Entry IMPORTANT NOTE: The operation of the Security and Convenience System as described in this manual is applicable to most vehicles. However, due to the configuration of some vehicles, some functions AND/OR SAFETY PRECAUTIONS may not apply.
-
Page 2: Keyless Entry
KEYLESS ENTRY 1. The LOCK icon button on the transmitter is used to lock the vehicle's doors, the UNLOCK icon button is used to unlock the vehicle's doors. To lock or unlock the doors simply press and release the desired function button one time. As a keyless entry unit, for your convenience, the parking lights will flash twice when the doors are locked and once when the door are unlocked. - Page 3 turned off. With the turbo timer mode selected on, after you've arrived at your destination, while the engine is still running, set the parking brake, pause 2 seconds, then turn the ignition switch to the off position. The engine will continue to run the allotted time according to the selection during installation.
- Page 4 Code Systems, Inc. Limited Lifetime Warranty Code Systems Inc. (“CODE”) warrants to the ORIGINAL PURCHASER of this CODE vehicle security product (the “Product”), purchased from an authorized CODE dealer, that (except as provided below) should this Product under normal use and conditions, be proven defective in material or workmanship DURING THE LIFETIME OF THE VEHICLE IN WHICH IT WAS ORIGI- NALLY INSTALLED, such defect(s) will be repaired or replaced (at CODE’s option) without charge for parts directly related to repairs of the defect(s).
-
Page 5: Fcc Compliance
FCC COMPLIANCE This device complies with Part 15 of the FCC rules and with RSS-210 of Industry Canada. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including any interference that may cause undesired operation. - Page 6 128- 6 of 6...