Generac Power Systems GC2800B Owner's Manual page 14

General Information and Setup
NOTE: It may be necessary to turn chute rotation handle
on control panel to align the cable end with the worm
gear in the bracket.
15. See Figure 2-14. Place rotation bracket cable (Y)
into connecting plate (Z).
Z
Figure 2-14. Rotation Bracket Cable
16. See Figure 2-15. Install eyelet end (A) of deflector
cable (B) onto deflector lever (C) and secure with
pin (D).
D
A
B
Figure 2-15. Deflector Cable Installation
17. Loosen top jam nut (E), slide threaded portion of
deflector cable into bracket (F) and tighten two jam
nuts against bracket using two 13mm wrenches.
10
18. See
Y
19. See
011060
T C
F
E
011061
Figure 2-16. Screw handles (G) onto shift and
deflector levers, and tighten jam nuts (H) using a
17mm wrench.
G
H
Figure 2-16. Lever Handles Installation
Figure 2-17. Use wire cutters to cut cable tie
securing heated grip connector (I) and insert
heated grip connector into harness plug (J).
I
J
Figure 2-17. Heated Grip Connector
Owner's Manual for Snow Blower
011062
011063