HighPoint RocketRAID 2700 Series User Manual page 12

4. After inst 4 talling the ada
5 5. The Rock ketRAID 2720
6 6. Each Min ni-SAS cable c
Note: Many y server-level
chassis back kplane, rather
procedures.
5 5. Close and s secure the syst
5 5 - Verify ying Instal
O Once the host adapter and h
properly recog p gnized.
1. Power on th he system. If t
d during boot up p.
2 2. Press Ctrl+ +H to access th
The BIOS Uti T ility will displa
Make sure all M attached drive
a and check the power and ca
apter, attach ha ard drives to th
0 (illustration) utilizes 2 Min
can support up p to 4 hard driv
chassis includ de hard-drive h
than directly t to each individ
tem chassis.
llation
hard drives hav ve been install
the system det tects the presen
he RocketRAI ID adapter's B
ay information n about hard d
es are detected d by this utility
able connection ns.
he host adapte er using the da
ni-SAS to Min ni-SAS Cables
ves. Consult th he chassis man
hot-swap bays s. For these sy
dual hard driv ve. Consult the
led into the ch hassis, boot-up
nce of the ada apter, the Rock
BIOS Utility.
drives attached d to the adapte
y. If any of the e hard drives a
12
ata cable.
s (included in each retail box
nual for prope er installation p
stem chassis, cables are atta
e chassis manu ual for proper
p the system to o verify that th
ketRAID BIOS S Utility will b
er.
are not detecte ed, power dow
x).
procedures.
ached to the
installation
he hardware is s
be displayed
wn the system