HighPoint RocketRAID 2700 Series User Manual page 11

Port2 and Port P t3 are external
Each port can E support up to
L LED Connec tions
LED connecto L ors (Drive-acti
indicate the ac i ctivity and fail
A1, F1 A
A1 provides L A LED support fo
BEEP1-Spea B ker
Alarm (speake A er): the speake
J J1
This jumper su T upports SAF-T
2 2 - Install ling the R
N Note: Make su ure the system
The RocketRA T AID 272x incl
in place of the i e standard brac
1. Open the system chassi
2 2. Remove t the PCI slot/br
3 3. Gently in nsert the Rocke
shows Ro ocketRAID 27
l Mini-SAS po orts (SFF-808
o 4 SATA/SAS S hard disks.
ivity/Drive-fai ilure): The Ro
lure status of h hard drives att
for Drive Activ vity, while F1
LED conne ection table
Co onnection
s
A1 1
F1
er emits and au udible alarm i
TE interface ( (I2C).
RocketRAI ID Host A
m is powered-o off before insta
ludes both stan ndard and low
cket, dependin ng upon the ch
is and locate a an unused PCI
racket cover.
etRAID card i into the PCI-E
720).
8).
ocketRAID 27 21 host adapte
tached to the c card's 4/8 SAT
supports Driv ve Failure.
Pin N umber
Pin 1
Channe el 1
Channe el 5
in the case of D Drive/array fa
Pin Numb ber
Pin1
Pin2
Pin3
Adapter
alling the Roc cketRAID host
w-profile brack kets. It may be
hassis design.
I-Express x8.
Express slot, an nd secure the b
11
er has 2 LED connectors tha
TA/SAS chann nels.
Pin 2 Pin3 Pin4
Channel 2 Channel 3 Channel 4
Channel 6 Channel 7 Channel 8
ailure.
PIN N description
SCL L
GN ND
SDA A
t adapter.
e necessary to attach the low
bracket to the system chassi
at are used to
w-profile brack ket
is (illustration n