Service; In Case Of The Following - Hussmann microSC MDN-BA Installation & Operation Manual

P/N 9FQ-6-P110-075-00_B

IN CASE OF THE FOLLOWING:

LED Lamp does not work:
Contact your Hussmann representative to
replace LED lamp fixtures . Fixtures must be
replaced with like fixtures .
When not using the merchandiser for a long
period of time:
Remove all items from the merchandiser, and
the power plug from the power socket . Clean the
inside of the cabinet, and wipe away any moisture .
Make sure not to store the unused case in a place
where children can play .
Damage to the power cord or plug:
If the cord is damaged, unplug the cord, and contact
your Hussmann representative for replacement . Do
not allow the the wheels of the merchandiser to
rest on the cord .
Water on the floor:
If there is water around the merchandiser, check
overflow drain pan underneath the case, and dispose of
any accumulated water or dirt in the pan . Wicking
plates may need replacement .
— LOCK OUT / TAG OUT —
To avoid serious injury or death from electri-
cal shock, always disconnect the electrical
power at the main disconnect when servicing
or replacing any electrical component. This
includes, but is not limited to, such items as
doors, lights, fans, heaters, and thermostats.
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.

SERVICE

When moving the case a long distance:
Use a trolley . Caution must be observed when
moving the case to prevent it from toppling over if
it is tilted more than necessary .
LED POWER SUPPLY LOCATION
The LED driver delivers DC power to the LED
Lamp . The power supply is located behind the
panel on the righthand side of the case . If it is
determined that the power supply is not working
and needs to be replaced, replace it with like
components . Failure to place with a similar rated
power supply will cause the LED lamp to be
damaged or not work properly .
Product will be degraded and may spoil if
allowed to sit in a non-refrigerated area.
LED Driver
(Power Supply)
Open Vertical Merchandisers
4-1