Advertisement
TUNE/SEEK/TRACK ( /
To manually select a radio station, momentarily press the Up Tuning
(
/
) button to advance the unit higher in 400kHz steps, or the
Down Tuning (
/
) button to tune lower in 400kHz steps within
the selected band. This tuning mode is the default Automatic mode.
Pressing and holding either button for longer than 2 seconds will
enter the Manual tune mode; MANUAL will momentarily appear on
the display, and the radio will rapidly tune in the upward or downward
direction, and stop when the respective button is released.
In addition, in the Manual mode, when either button is momentarily
pressed, the radio will tune upward or downward in 200kHz steps.
If no tuning is performed for at least 5 seconds in the MANUAL
mode, the radio will automatically revert to the Automatic mode
and AUTO will appear for about 2 seconds on the display.
During disc play, each press of either button will increment or
decrement the track number accordingly. When the button is pressed
and held for at least 2 seconds, the elapsed time for the current
track will increase or decrease rapidly and stop at the desired point
within the track when the button is released. (Refer to the
Cue/Review functions.)
FM MONO/STEREO OPERATION
During FM radio operation, under normal reception conditions, the
unit operates in the stereo mode as indicated by the ST indication
on the display panel when tuned to an FM stereo signal which is
reasonably strong. However, if the stereo signal is too weak or
noisy, the ST indication will appear intermittently or disappear
completely. If the stereo signal is too noisy for comfortable listening,
use the Auto-Store (AS) function to switch to local FM stations
having stronger signals.
- /
) BUTTONS
STATION SCAN ( R.SCAN) BUTTON
Press this button momentarily to commence a scan of all stations
in the current band whose signal strengths are the strongest (each
station number will appear flashing on the display panel for 5
seconds during station search). Press the button again momentarily
to stop the Scan operation and remain on the current local
frequency. To return to one of the frequencies preset into the current
band, press the desired pre-set button.
STATION PRE-SET
To set any of the 6 pre-set stations in each band, use the following
procedure:
1. Turn the radio on and select the desired band.
2. Select the first station to be pre-set using the TUNE/SEEK/
bm
TRACK Controls
tuning button.
3. Press the pre-set button to be set and continue to hold it
in for approximately 2 seconds. The channel preset number
(1-6), will appear on the display panel indicating that the
station is now set into that preset memory position. The
station can now be recalled at any time by pressing that
button.
4. Repeat the above procedure for the remaining 5 pre-sets on
that band and for the other 3 bands on the unit.
-5-
or the Preset Scan/Auto-Store (PS/AS)
Advertisement
