Audiovox CDI-100 Owner's Manual page 7

Cd changer controller wireless remote control (optional)
Table of Contents

Advertisement

9
INFRARED SENDER
The wireless signal from the remote control is sent from this lens.
For optimal range and performance of the remote control, always
aim the Sender at the Remote Sensor
Do not let your finger interfere with the signal and make sure the
lens does not become blocked by dirt, dust, etc. If necessary, clean
the lens with a soft dry cloth or cotton swab.
NOTES ON REMOTE CONTROL USE:
The remote control operates on a 3 volt lithium battery (type
CR-2025). Install the battery into the compartment at the
bottom of the remote control, making sure to observe correct
polarity (match "+" side of battery to "+" indication on compart-
ment).
If the remote control fails to operate, always check battery
condition and replace if necessary before servicing the unit.
Dispose of batteries properly. Do not heat, disassemble, or
throw batteries into a fire.
Keep the remote control away from areas where it may be
exposed to heat, moisture or sunlight.
bl
on the wired control unit.
-6-

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cdc-10r

Table of Contents