D-Link DAP-2682 User Manual page 25

Section 3 - Configuration
Transmit Power:
This setting determines the power level of the wireless transmission. Transmitting power can be adjusted to eliminate overlapping
of wireless area coverage between two access points where interference is a major concern. For example, if wireless coverage is
intended for half of the area, then select 50% as the option. Use the drop-down menu to select 100%, 50%, 25%, or 12.5%.
WMM (Wi-Fi Multimedia):
WMM stands for Wi-Fi Multimedia. Enabling this feature will improve the user experience for audio and video applications over
a Wi-Fi network.
Ack Time Out To effectively optimize throughput over long distance links enter a value for Acknowledgement Time Out between 25 and 200
(2.4 GHZ, 48~200):
microseconds for 5 GHz or from 48 to 200 microseconds for 2.4 GHz in the field provided.
Short GI:
Select Enable or Disable. Enabling a short guard interval can increase throughput. However, be aware that it can also increase
the error rate in some installations due to increased sensitivity to radio-frequency installations.
IGMP Snooping: Select Enable or Disable. Internet Group Management Protocol allows the AP to recognize IGMP queries and reports sent between
routers and an IGMP host (wireless STA). When IGMP snooping is enabled, the AP will forward multicast packets to an IGMP host
based on IGMP messages passing through the AP.
Multicast Rate : Select the multicast rate to adjust multicast packet data rates.
Multicast Bandwidth Adjust the multicast packet data rate here. The multicast rate is supported in AP mode, (2.4 GHZ and 5 GHZ) and WDS
Control :
with AP mode, including Multi-SSIDs.
Maximum Multicast
Set the multicast packets' maximum bandwidth pass through rate from the Ethernet interface to the Access Point.
Bandwidth :
HT20/40 Coexistence : Enable this option to reduce interference from other wireless networks in your area. If the channel width is operating at 40 MHz
and there is another wireless network's channel overlapping and causing interference, the Access Point will automatically change
to 20 MHz.
Transfer DHCP Offer to Enable to transfer the DHCP Offer to Unicast from LAN to WLAN. It is suggested to enable this function if stations number is larger
Unicast :
than 30.
D-Link DAP-2682 User Manual 25