Canon Super Glider Quick Start Manual

Papercraft Toy Series
Canon Papercraft Mini-book
Super Glider
Toy Series
This model is a glider with a simple design.
A glider is an airplane without an engine. It
must skillfully use uprising air currents to
keep it flying.
You can adjust this glider so that it flies very
well.
*Cut out the card above and save it. You can collect the cards from each of the Papercraft
projects to make your own mini-book!
Directions
(If you want to fly the glider outside, print these patterns
on white construction paper for inkjet.)
1. Build the WINGS
Apply glue and
fasten together.
Curve the WING, so that the highest spot on the WING
is a point one-third of the way from the front edge
of the WING, when viewed from the side.
The black lines indicate
one-third of the way
from the front edge of the WING.
WING, viewed
from the front.
15˚ 15˚
Left Right
Super Glider
WING (Underside)
WING, viewed
from the side.
Front
Back edge
1/3
edge
Curve the WING so the
center is raised about
1 mm (1/25 inch).
Bend the left and right sides
of the WING upward
from the center line, about 15%.
(section 1)
2. Build the FUSELAGE
FUSELAGE (Right)
FUSELAGE (Left)
Glue together.
Cut away the gray areas around
the FUSELAGE and bend the tabs outward.
3. Put it together
WING
FUSELAGE
Paper clips
Attach two paper clips.
Canon is a registered trademark of Canon Inc.
R
Apply glue to the inside surfaces
of the FUSELAGE and glue the two
pieces together,
starting at the tail and working
your way forward to the nose.
Using the triangles on the
WINGS as guides, align the center
of the WING with the FUSELAGE
and glue it down.
TAIL
Glue the WINGS and TAIL in place.