Pendulum Support, Removing And Installing; Engine, Supporting In Installed Position - Volkswagen Golf 2015 Repair Manual

2.4 Pendulum Support, Removing and In‐
stalling
Removing
Caution
This procedure contains mandatory replaceable parts. Refer
to component overview prior to starting procedure.
Mandatory Replacement Parts
♦ Bolts - Pendulum Support
– Remove the noise insulation. Refer to ⇒ Body Exterior; Rep.
Gr. 66 ; Noise Insulation; Overview - Noise Insulation .
– Remove the bolts -1, 2 and 3- and remove pendulum support.
Installing
Install in reverse order of removal. Note the following:
Tightening Specifications
Step Bolts Tightening Specification/Additional Turn
1. -2 and 3-
2. -1-
3. -1 to 3-
♦ Refer to ⇒ Body Exterior; Rep. Gr. 66 ; Noise Insulation;
Overview - Noise Insulation .
2.5

Engine, Supporting in Installed Position

Special tools and workshop equipment required
♦ Engine Support Bridge - 10-222A-
♦ Engine Support Bridge - Engine Support 18 - 10-222A/18-
♦ Engine Support Bridge - Engine Support 29 - 10-222A/29-
♦ Engine Support - Basic Set Square Pipe - T40091/1- and En‐
gine Support - Movable Joint - T40091/3- from the Engine
Support - Basic Set - T40091-
♦ Engine Support Brackets - T40093/3- and Engine Support
Brackets - T40091/3-6- from the Engine Support - Supplement
Kit - T40093A-
♦ Engine Support Bridge - Special Hook (2 pc.) - 10-222A/20-
♦ Engine/Gearbox Support Shackle (2 pc.) - 10-222A/12-
Engine Mechanical, Fuel Injection and Ignition - Edition 04.2015
50 Nm
130 Nm
Turn an additional 90°
Golf 2015 ➤ , Golf Variant 2015 ➤
2. Subframe Mount
33