Toggling the Operating Band
Normally, both operating bands are displayed on the top half and bottom half of the
transceiver screen. This is Dual band.
With one of the bands selected, change the frequency and radio operating mode.
• The selected band (displayed in white letters) is called Operating band.
• The other band (displayed in gray letters) is called Sub-band.
• Each time pressing the [A/B] key toggles the operating band.
Selecting a Frequency Band
1. Press the [BAND] key to select the desired frequency band.
Tuning to a Frequency
● DIAL knob
By pressing the DIAL knob and then rotating the DIAL knob, the frequency will
change in 1 MHz steps.
● The numeric keys
1. Press the [F(SETUP)] key.
2. Rotate the DIAL knob (Band A) to select "ENT FRQ", the press the DIAL knob
(Band A).
3. Enter the frequency.
Rotate the DIAL knob (Band A) to select numbers, then press the DIAL knob (Band
A) to move the cursor to the right.
4. Repeat step 3 to input the frequency.
Changing the Frequency Step
The DIAL knob rotation frequency step may be changed. Normally, the factory default
setting will provide a good frequency step.
1. Press and hold the [F(SETUP)] key.
2. Rotate the DIAL knob (Band A) to select "CONFIG", then press the DIAL knob (Band
A).
3. Rotate the DIAL knob (Band A) to select "7 STEP", then press the DIAL knob (Band
A).
4. Rotate the DIAL knob (Band A) to change the frequency step.
5. Press the PTT switch to save the setting and return to normal operation.
In the default setting, of the frequency step is set to "AUTO", which automatically provides
a suitable frequency step according to the frequency band.
14
Application for FCC/IC
FCC ID: K6620715X40
IC: 511B-20715X40