Installation Requirements; Electrical Requirements - Wolf Vacuum Seal Drawer Installation Manual

Hide thumbs Also See for Vacuum Seal Drawer:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
SP EC I FI C AT IO N S

Installation Requirements

The vacuum seal drawer can be installed in a standard or
flush inset application. Finish the edges of the opening.
They may be visible when the drawer is open.
For standard installations, the face trim overlaps stiles and
rails. Refer to the chart below.
For flush inset installations, a minimum 3 mm reveal is
required on all sides. To ensure consistent reveals, each
corner of the opening must be exactly 90°.
An anti-tip block must be installed to prevent the vacuum
seal drawer from tipping forward when opened.
IN S TA LL AT I O N R E Q U IR E M E NT S
BA SE S UP P O RT
Vacuum Seal Drawer
TRI M OV ERLA P
Top
Bottom
Sides

Electrical Requirements

Installation must comply with all applicable electrical codes
and be properly grounded (earthed).
Locate the electrical supply as shown in the illustrations on
the following pages. A separate circuit servicing only this
appliance is required.
E LECTR ICAL R EQUI R EM ENTS
Electrical Supply
220–240 V AC, 50/60 Hz
Service
Power Cord
M I N
34 kg
0 mm
0 mm
18 mm
RATING
PLATE
Rating plate location
IMPORTANT NOTE:
Connection of this appliance should be
through a fused connection unit or a suitable isolator, which
complies with national and local safety regulations. The
on/off switch should be easily accessible after the appli-
ance has been installed. If the switch is not accessible after
installation (depending on country) an additional means of
disconnection must be provided for all poles of the power
supply. When switched off there must be an all pole contact
gap of 3 mm in the isolator switch. This 3 mm contact dis-
320 W
connect gap must apply to any isolator switch, fuses and/or
.9 m
relays according to EN60335.
Electrical
Shock
Hazard
Plug power cord directly into a properly
grounded (earthed) outlet.
Do not defeat the grounding (earthing)
nature of the plug.
Do not use adapter or extension cord.
Failure to follow these instructions could
cause serious injury or death.
See installation instructions
|
wolfappliance.com
3

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents