Advertisement
Available languages
Available languages
SPE C IF I CAT I ON S
Installation Requirements
The vacuum seal drawer can be installed in a standard or
flush inset application. Finish the edges of the opening.
They may be visible when the drawer is open.
For standard installations, the face trim overlaps stiles and
rails. Refer to the chart below.
For flush inset installations, a minimum
required on all sides. To ensure consistent reveals, each
corner of the opening must be exactly 90°.
An anti-tip block must be installed to prevent the vacuum
seal drawer from tipping forward when opened.
INS TA L L AT IO N R E QU I RE M E NT S
BA S E S U PP ORT
Vacuum Seal Drawer
T R IM O VE RL AP
Top
Bottom
Sides
Electrical Requirements
Installation must comply with all applicable electrical codes.
Locate the electrical supply as shown in the illustrations
on the following pages. A separate circuit servicing only
this appliance is required. A ground fault circuit interrupter
(GFCI) is not recommended and may cause interruption of
operation.
1
/
"
reveal is
(3)
8
E L E C T R I C AL R E Q U I R E M E N T S
Electrical Supply
Service
Receptacle
Power Cord
M IN
75 lb
(34 kg)
0"
(0)
0"
(0)
11
/
"
(18)
16
Rating plate location
RATING
PLATE
grounded, 120 VAC, 60 Hz
10 amp dedicated circuit
3-prong grounding-type
3'
(.9 m)
|
wolfappliance.com
3
Advertisement
