Menu Settings - Tesla 32T320BH User Manual

ENG
Scan Mode
Channel Type
Service Type
It is recommended to use the default settings.
DVB-T/T2 installation
Terrestrial Setting
Here you only need to press OK to start searching.
All settings are automatically set by country selection you made in first step.
NOTE: If you have an active antenna, please check the user manual of the antenna for external power supply.
The TV can NOT supply power used for an active antenna.
DVB-C installation
Cable Setting
Press  to highlight your settings.
Scan type
NOTE: Full scan will have a duration of approximately 20 minutes, depending on your cable network.
Frequency
Network ID
Symbol
NOTE: Please check the settings for your cable system used by your provider!

MENU SETTINGS

Menu control (DTV mode)
Press MENU to enter the main menu. Press  to select an item. Press  and OK to select the
submenus. Press MENU to exit the item.
Picture menu
Picture Mode
Colour Temp
Noise Reduction
In the Personal mode, settings can be changed for Brightness, Contrast, Colour, Tint and Sharpness.
Choose between Default (recommended), Blind Scan and Network
Select Free to search Free-To-Air channels only.
Select Scramble to search Encrypted channels only. All Channels to search FTA
and Encrypted channels
Select DTV to search DTV channels only, RADIO to search radio channels only
or All for a complete search.
You can select Network Scan or Full. (Default Network Scan for quick search advised)
Please enter (with 0 ~ 9) the main frequency used by your provider in KHz.
Please enter (with 0 ~ 9) the used Network ID from your provider.
Please enter (with 0 ~ 9) the used Symbol from your provider. (Ks/s)
Select the automatic picture control mode. Available choices are Dynamic,
Standard, Mild and Personal.
Select the overall colour tone of the picture. Available choices are Cold,
Normal and Warm.
Eliminates noise in the picture. Available choices are:Off, Low, Middle, High and
Default
8