Table of Contents
Advertisement
C
1
1)
D
1
1
2
3
4
E
1
2
1-4
2
2)
2
3
4
3
4
LOCK
Mounting the Lens
Compatible lenses
1 C mount lens
1) 9 mm (
2 CS mount lens
2) 4 mm (
Notes
• Be sure to attach the lens mount cap when the lens is not mounted.
• Only lenses that are suitable for a 1/3type CCD should be used with
this camera. If lenses for a 2/3type or 1/2type CCD are used, the view
angle will be different.
Fitting the DC servo auto-iris lens plug
The camera is supplied with a plug for inserting into the LENS connec-
tor on the side of the camera. When fitting a DC servo auto-iris lens,
you will need to replace the plug on the lens cable with the plug
supplied. Replace as follows:
1 Cover
2 Lens cable
3 Rib (If the cable is thick and the plug cover does not seat properly,
cut away this rib.)
4 Lens plug
1
Remove the plug cover and solder the lens cable wires to the pins
on the plug supplied. The pin assignment is as follows:
4
2
1 Pin 3:
2 Pin 1:
3 Pin 2:
4 Pin 4:
3
1
2
Put the cover on the plug.
Fitting the lens
When using a DC servo auto-iris lens, fit it as follows. For a manual-iris
lens, omit step 3.
1
Unscrew lens mount cap.
2
Screw in the lens.
3
First, replace the plug on the lens cable with the plug supplied with
the camera. Then, connect the camera cable plug to the LENS
socket.
4
Loosen the back focus LOCK screw. Adjust the back focus by
turning the C/CS adjustment ring in accordance with the type of lens
fitted (C-mount or CS-mount). Once adjusted, tighten the back focus
LOCK screw. (The factory setting is CS-mount.)
Caution
When attaching a C-mount type lens, be sure to turn the C/CS adjust-
ment ring fully in the "C" direction. When the C/CS adjustment ring is
set to "CS," mounting any lens with a mount projection of more than 4
mm may damage the internal parts of the camera.
C
3
/
inch) or less
8
5
/
inch) or less
32
D
Drive (+)
Control (–)
Control (+)
Drive (–) (Ground)
E
SSC-DC132P/134/134P/138P
Advertisement
Table of Contents
