THIS NOTE IS COMMON FOR PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS.
(In addition to this, the necessary note is printed in each block.)
For Printed Wiring Boards.
Note:
• X : Parts extracted from the component side.
• Y : Parts extracted from the conductor side.
•
f
: Internal component.
•
: Pattern from the side which enables seeing.
(The other layers' patterns are not indicated.)
Caution:
Pattern face side:
Parts on the pattern face side seen
(Conductor Side)
from the pattern face are indicated.
Parts face side:
Parts on the parts face side seen from
(Component Side)
the parts face are indicated.
Caution:
Pattern face side:
Parts on the pattern face side seen
(SIDE B)
from the pattern face are indicated.
Parts face side:
Parts on the parts face side seen from
(SIDE A)
the parts face are indicated.
• Indication of transistor.
C
Q
These are omitted.
B
E
• Abbreviation
AUS
: Australian model
BR
: Brazilian model
CND : Canadian model
E2
: Latin American model
TW
: Taiwan model
HCD-MX700Ni/MX750Ni
For Schematic Diagrams.
Note:
• All capacitors are in μF unless otherwise noted. (p: pF) 50
WV or less are not indicated except for electrolytics and
tantalums.
• All resistors are in Ω and 1/4 W or less unless otherwise
specifi ed.
•
f
: Internal component.
• 2 : Nonfl ammable resistor.
• C : Panel designation.
Note:
Note:
The components identi-
Les composants identifi és
fi ed by mark 0 or dotted
par une marque 0 sont
line with mark 0 are criti-
critiques pour la sécurité.
cal for safety.
Ne les remplacer que par
Replace only with part
une pièce portant le nu-
number specifi ed.
méro spécifi é.
• A : B+ Line.
• B : B– Line.
• Voltages and waveforms are dc with respect to ground
under no-signal (detuned) conditions.
– BD96/BD96U Board –
no mark : CD PLAY
– Other Boards –
no mark : TUNER FM
<
> : TUNER DAB
*
: Impossible to measure
• Voltages are taken with VOM (Input impedance 10 MΩ).
Voltage variations may be noted due to normal production
tolerances.
• Waveforms are taken with a oscilloscope.
Voltage variations may be noted due to normal production
tolerances.
• Circled numbers refer to waveforms.
• Signal path.
F
: TUNER
J
: CD PLAY
d
: USB
i : iPod/iPhone
f
: AUDIO IN
L
: DAB
G
: LAN
• Abbreviation
AUS
: Australian model
BR
: Brazilian model
CND : Canadian model
E2
: Latin American model
TW
: Taiwan model
• Circuit Boards Location.
MAIN board
LCD board
POWER board
IP board
JACK board
JUNCTION board
25
25
HCD-MX700Ni/MX750Ni
SP board
DAB board (MX750Ni)
MODULE (DAB TUNER) (MX750Ni)
NET board
WIRELESS LAN MODULE
TUNER (FM)
BD96U board
KEY board
MS-203 board
USB board