Chassis Assembly; Board - Sony SNC-DS10 Service Manual

1-2-2. Chassis Assembly

1. Remove the upper case N assembly.
(Refer to Section 1-2-1.)
2. Disconnect the LAN cable and power input cable from
the connectors (CN301 and CN809) on the SY-358

board.

3. Remove the two hooks in the direction of the arrow,
then remove the board cover N.
4. Remove the three screws (PSW2.6 x 8), then remove
the chassis assembly.
5. Disconnect the two harnesses from the connectors
(CN807 and CN808) on the SY-358 board.
Hooks
Board cover N
Chassis assembly
CN808
CN807
SY-358 board
6. To install, reverse the removal procedure.
1-2
PSW2.6 x 8
Harnesses
Power input
cable
LAN cable
CN301
CN809
1-2-3. SY-358 Board
n
When installing the SY-358 board, be careful not to catch
the harness.
1. Remove the upper case N assembly.
(Refer to Section 1-2-1.)
2. Remove the chassis assembly.
(Refer to Section 1-2-2.)
3. Remove the LAN earth plate B.
4. Remove the screw, then remove the SY-358 board.
5. Disconnect the two harnesses from the connectors
(CN801 and CN811) on the SY-358 board.
6. Remove the radiation rubber (large) and radiation
rubber (small) from the SY-358 board.
PSW2.6 x 8
SY-358 board
CN801
Harness
Radiation rubber
(small)
Radiation rubber
(large)
7. To install, reverse the removal procedure.
LAN earth plate B
CN811
Harness
SNC-DS10/DM110