Table of Contents
Advertisement
Practical information
4. Charging starts automatically. The
CHARGING indicator lamp on the control
unit comes on to indicate that charging is
in progress.
Several signals indicate that the vehicle's
battery is charging:
-
The right-hand rear lamp flashes 5 times at
the start of the charge.
-
The charging indicator lamp (in the form of
a green plug) in the display screen flashes
continuously.
Flashing green continuously: charging is in
progress.
Fixed green: charging is complete.
-
The indicator lamp on the charging shut-off
button gives the same indication as the
charging indicator lamp on the display.
Flashing green continuously: charging is in
progress.
Fixed green: charging is complete.
If the central screen is lit, the message
"Charging" will be displayed as well as an
estimate of the charge time remaining.
62
Notes on charging
Once you have connected your
E-MEHARI, you have 30 seconds to lock
the vehicle.
After this, your E-MEHARI will remain
unlocked.
However, as a security measure, the
driving permissions will be cancelled.
-
If you wish to use your E-MEHARI
again, offer up your key ring in front of
the RFID reader to regain the driving
permissions.
-
To lock your E-MEHARI, scan twice.
The 1
st
time will be interpreted as
a recovery of the driving permissions, the
2
nd
time will lock the vehicle.
https://www.automotive-manuals.net/
Stopping the charge
The charging nozzle will only disconnect if
your E-MEHARI is unlocked using the personal
RFID key ring.
1.
Press the charging shut-off button in
the charging socket panel, wait until the
charging nozzle is unlocked then pull it
out. If you do not remove the charging
nozzle within the next 10 seconds, the
vehicle starts charging again. You will
then have to start the operation again.
2.
Refit the protective cover on the charging
nozzle.
3.
Disconnect the plug from the power point.
Advertisement
Table of Contents
