Power Board - Sony HBD-TZ215 Service Manual

HBD-TZ215/TZ715

2-10. POWER BOARD

7 plate flow control (AMP)
8 four screws
(BV3 (3-CR))
0 POWER board
6 two claws
9 holder PC board
Keep the wire tied up from lying on
the heat sink and the POWER board.
CN906
14
5 screw
(BV3 (3-CR))
1 power cord connector
(CN901)
USB wire
Tie up with LP501.
heat sink
CN509
CN901
POWER board
8 four screws
(BV3 (3-CR))
4 connector
(CN906)
3 connector
(CN904)
2 Lift up two lead pins.
heat sink
Tie up with LP3002.
Keep the wire tied up from lying on
the heat sink and the POWER board.
Keep a distance of more than 6.5 mm
between the wire and CN901.
Draw the USB wire through CN3000.
black
Have the USB wire spread on the inside
of the claws of the chassis.
POWER board
6 mm
rear side
LF901
CN901
red
CN3000
USB wire