Samsung WF1114 Series Service Manual page 25

Part
Heater
Figure Description
1. Separate the Back Cover.
2. Separate the Connection Housing (3).
3. Remove the screw (1).
4. Separate the Holder and Connection
Housing.
5. Remove the nut holding the heater and
separate the Heater.
Use box Drivers (Socket size: 10mm)
6. Remove the Heater from the Tub.
Caution
Make sure to insert
the Heater into the
correct position of
the bracket inside
the Tub when
reassembling it.
Otherwise, there is
a danger of a fire.
Make sure to push it inwards until the
packing part comes into the Tub completely
when reassembling it so that the packing
part is completely stuck to the Tub.
Fasten the holding nut with a force of 5Kgf/
cm2.
If the nut is not fastened properly, there is a
danger of water leaking.
Disassembly and Reassembly _ 23