Asko D1976 User Manual page 13

THE DISPLAY WINDOW
The display window has four functions. It can show the temperature, the fault indication, the
remaining programme time and the re-programming
SHOWS HOW MUCH PROGRAMME TIME REMAINS.
When a programme starts, the display shows the length of time it took when it was last run. As the
programme proceeds, the display counts down, showing the time remaining. Times can vary slightly
from one time to another, due to variations in the incoming water temperature etc.
NB! The programme time is not stored in the memory if you open the door, or if the machine has a
fault indication during the programme.
As the time proceeds, the time is counted down and the estimated time remaining is displayed . If the time
exceeds 60 minutes, the display alternates between the number of hours, followed by h, and the number of
minutes: e.g. 1h–25–1h–25, which says that 1 hour and 25 minutes remain of the programme.
NOTE!
If the machine is connected to a coldwater suply, the time display for remaining time will be incorrect the
first time that each programme is run. The timo on the display stops on 1 minute until the programme is
done. Do not open the door until the machine has stopped.
On subsequent runs of the respective programmes, the machine will calculate the time on the basis of how
long the programme took on the previous run. The figures are approximated.
13