Table of Contents
Advertisement
The compression circuit features a VCA-less design and utilizes either optical
(Vactrol®) or tube, dual triode electronics for superior musical performance. The
compressor is soft knee by design. Although it is capable of providing a thoroughly
"squashed" signal, it was designed to excel in areas where transparent and musical
dynamics control is desired. The beauty of the optical design is its ability to apply heavy
amounts of compression without pumping and breathing like VCA-based compressors.
The tube compressor is capable of smoothly compressing fast-rising signal sources
without undue side effects. In most cases you will hear the results of the compression
without hearing the compressor.
The tube-based equalizer was designed to help "fix" the instruments that give us
headaches when recording (i.e., kick, snare, bass, toms, guitar amps, voice, etc.). The
two sweepable parametric bands and selectable shelving bands have been optimized for
musical instruments. The two sweepable bands overlap each other as well as the high
and low shelving bands, providing you with the ultimate in flexibility. This EQ design
gives you all the control you need to effectively dial in great sounds from even the
poorest of sources.
Setting Up
Unpacking
Your Pro Channel was packed with care at the factory. The shipping carton was
designed to protect the unit during initial shipment. Please retain this carton for use in
transporting the Pro Channel, or in the unlikely event that you need to return your unit
for servicing.
AC Power Hookup
The Pro Channel has an internal power supply designed to operate at 100 to 125VAC,
50 to 60Hz. Units manufactured for use outside of the United States have been modified
to comply with the required electrical specifications. Under no circumstances should the
power cable be altered. If the cable becomes cut or damaged, discontinue use and have
it replaced before operating.
Audio Connections
Audio connections to and from the Pro Channel are balanced XLR (Pin 2 = Hot (+), Pin
3 = Cold (-), Pin 1 = Ground) and unbalanced ¼" (Tip = Hot (+), Sleeve = Ground).
The insert points between the preamp and compressor and the compressor and equalizer
are unbalanced ¼" (Tip = Hot (+), Sleeve = Ground) connectors.
We recommend using only high-quality cables and connectors.
- 7 -
Hide quick links:
Advertisement
Table of Contents
