Table of Contents
Advertisement
Frequently Asked Questions
Problem
flashes in the timer
display and the cooktop
switches off automati-
cally.
After turning on the
cooktop, appears in
the timer display for
several seconds. The
cooking zones don't
heat up.
A burner turns itself off
automatically.
A burner or the whole
cooktop switches off
automatically.
The booster has auto-
matically turned off
early.
The burner is not work-
ing in the usual way
with the set power level.
Power setting 9 is auto-
matically reduced if you
select power setting 9
on two linked burners
or extended zones at
the same time.
Auto Heat-up is turned
on, but the food does
not start cooking.
A noise can be heard
after the appliance is
turned off.
50
Possible cause and solution
One or more of the sensor controls are covered, e.g.,
by finger contact, food boiling over, or an object.
Clean off any dirt and/or remove the object (see
"Safety features – Safety shut-off").
The cooktop is in demo mode.
Deactivate demo mode (see "Programming").
It might have been turned on for too long.
You can use the burner again by turning it back on
(see "Safety features – Safety shut-off").
Overheating protection has been triggered.
See "Safety features – Overheating protection".
Overheating protection has been triggered.
See "Safety features – Overheating protection".
Overheating protection has been triggered.
See "Safety features – Overheating protection".
Operating both zones at power level 9 would exceed
the permitted maximum power for the cooktop.
Use another burner that is not linked.
Large amounts of food are being heated.
Start cooking at the highest power level, then re-
duce the power level manually.
The pan is not conducting heat properly.
Use a different pan that is able to better conduct
heat on an induction cooktop.
The fan will continue running until the cooktop has
cooled down. It will then turn itself off automatically.
Hide quick links:
Advertisement
Table of Contents
