Advertisement
I I n n t t r r o o d d u u c c t t i i o o n n
Thank you for purchasing the FX-1—and congratulations: You now own one
of the coolest and most sophisticated pieces of audio signal-processing avail-
able. Offering a superb level of processing and sound quality, the FX-1's spe-
cially designed integrated circuits and straightforward user interface quickly
and easily gives you access to all of its features.
F F e e a a t t u u r r e e s s : :
Two banks of 15 studio crafted presets.
30 effects algorithms including: reverb, delay, chorus, phase shifting, pitch
shifting, tremolo, panning, multi-effect combinations, and true
stereo effects.
Multi-effects processing offering up to three effects at once.
Dual Processing effects for processing each channel individually.
"More" options for each preset for more of the processing you need!
Adjustable input and output levels.
1/4" stereo inputs and outputs.
Portable design - Put it anywhere, take it anywhere.
Very low noise and wide dynamic range.
Designed & Manufactured in the USA.
Fill in the following information for your reference:
Date of purchase:
_________________________________
Purchased from:
_________________________________
Serial number:
121-______________________________
This is a great time to fill out the User Registration Card included with your
FX-1 to become a completely informed A R T Artist. Completing and return-
ing the card to us ensures you of becoming the first to know about exciting
new A R T products as well as any further developments from
A R T.
121-5004-101
2 2
C C o o n n n n e e c c t t i i o o n n s s : :
Despite the FX-1's sophistication, it's easy to interface the unit with
other equipment. All connections are made at the back of the
FX-1. Standard 1/4" inputs and outputs make patching simple.
Note: For best audio quality, always use high quality cables.
I I n n p p u u t t
The input is single-ended (unbalanced) with an impedance of 470k
ohms.
NOTE: Because the FX-1 is designed for line-level or instrument
operation, we don't recommended plugging microphones directly
into it. This is because most microphones have a very low output
and need to run into a mic preamp before anything. Use either a
mic preamp (like the A R T Tube MP), a mixer, or an amp's preamp
section to boost the level first (use the effects loop output, reverb
send or channel insert from a mixer or amp). A higher signal level
from a preamp or effects loop assures an optimum signal-to-noise
ratio in the FX-1, keeping hiss and distortion to a minimum.
O O u u t t p p u u t t
The output is single-ended (unbalanced) with a source impedance
of 1k ohm.
P P o o w w e e r r
Insert the supplied 9 Volt AC adapter's plug into the input labeled
POWER on the FX-1's back panel. The FX-1 is powered by an exter-
nal 9 Volt AC adapter. Always make sure that its output plug is
securely plugged into the rear of the FX-1, and that the adapter is
held firmly in an electrical outlet. Never operate the FX-1 or AC
adapter in the rain or in wet locations. If the AC adapter's cord is
ever cut or damaged, discontinue using it and replace the adapter
with a new one. To prolong its life, unplug the adapter when the
FX-1 is not in use. Refer to the label on the adapter or the specifica-
tions later in this manual for the appropriate operating voltages.
3 3
Advertisement
