SRAM RockShox Reba Series Service Manual page 24

Slide the lower leg assembly along the upper tubes until it stops
5
and the spring and damper shafts are visible through the shaft bolt
holes. Wipe all excess fluid from the outer surface of the lower
legs.
Install a new o-ring into the top gland of a new shaft bolt. Install a
6
new spring clip in the lower gland of the shaft bolt.
Apply a thick layer of grease around the diameter of the bolt head
and o-ring.
Replace the crush washers and crush washer retainers.
Dirty or damaged crush washers can cause leaks.
Insert the shaft bolts into the lower legs through the threaded
7
shaft bolt holes.
Use a torque wrench with a 5 mm hex bit socket to tighten the
bolts to 7.3 N·m (65 in-lb).
Insert the external rebound damper knob into the rebound damper
8
shaft bolt until it is secure. Adjust the rebound.
22
5 mm
7.3 N·m (65 in-lb)
LOWER LEG INSTALLATION