SRAM RockShox Reba Series Service Manual page 16

Firmly push the air assembly into the bottom of the upper tube
4
while gently rocking the air shaft side to side.
Orient the washers so that the aluminum support washer goes into
the upper tube first, followed by the wavy washer.
Install the snap ring onto internal snap ring pliers. Use the pliers to
5
push the air shaft into the upper tube while installing the snap ring
into its groove. The air shaft guide should be situated between the
snap ring eyelets.
Make sure the snap ring is securely fastened in the snap ring
groove. Check this by using the snap ring pliers to rotate the
snap ring back and forth a couple of times, then firmly pulling
down on the air shaft.
Snap rings have a sharper-edged side and a rounder-edged side.
Installing snap rings with the sharper-edged side facing the tool
will allow for easier installation and removal.
Insert the top cap into the top of the upper tube. Use a torque
6
wrench with a 24 mm socket to tighten the top cap to
7.3 N·m (65 in-lb).
14
24 mm 7.3 N·m (65 in-lb)
SOLO AIR SPRING INSTALLATION