Page 1
ARMIN Errol Chopping, February, 2016 General In February 2016 we had a Garmin GTN 650 (GPS) installed into VH-BAC. This document explains how to use two of its basic features: 1. How to use the Com radio 2. How to use the DirectTo feature...
On the top right of the screen on the GPS are the communications radio frequencies. There are two frequencies, the one on the very top is currently being used, the one below it is the standby. Basic Operation of the Garmin GTN 650 GPS Errol Chopping...
Page 3
Remember, only the top frequency is used, the lower one is standby. You can only flip them by touching the top frequency. You can only edit the bottom frequency, by touching Basic Operation of the Garmin GTN 650 GPS Errol Chopping...
Page 4
You must pick one of these, or Cancel. In this document we have chosen the top-most location: ‘Waypoint’. When you choose a location, you will see a keypad and you can type the code in. Basic Operation of the Garmin GTN 650 GPS Errol Chopping...
Page 5
To remove the direct-to location, click Remove. Override a DirectTo If you decide to go DirectTo one location when another is already entered, the most recent one entered is used. ----------- End of Document ----------- Basic Operation of the Garmin GTN 650 GPS Errol Chopping...