Operating Modes; Processor Preparation For Use; Use Of The Processor - AGFA ELANTRIX 95 S User Manual

OPERATING MODES

PREPARATION FOR USE
Ensure that the machine has been installed
according to instructions.
•
Place the excess developer drainage
pipe into the corresponding drum (dark
pipe);
•
check that the outlet tap is closed;
•
fill the developer tank with the required
amount of liquid;
It is very dangerous to operate the machine
without any liquids inside, as it may cause
irreparable damage to the pumps.
Before handling the necessary chemical for
the operation of the processor carefully
read the instructions provided in the
paragraph headed CHEMICAL PRODUCT
HANDLING.
•
Ensure that the machine is perfectly
level;
•
Insert the
replenisher into the replenisher liquid
drum (see service manual);
•
Insert the suction pipe marked gum into
the gum drum (see service manual);
•
Also ensure that water comes to the
processor at the required pressure;
•
Also ensure
connection is correct;
•
Switch on through the main switch;
•
Deactivate the emergency button if
necessary;
•
Remove the service key and close the
Plexiglas lids, if open;
•
Press the START button to activate the
line relay;
•
Switch on the processor by pressing
START;
•
Set the data for each function according
to the instructions of the paragraph
entitled
PROGRAMMING".
suction pipe marked
that the electrical
"PROCESSOR
English
Reset the plate counter to zero and the drying
temperature to 50°C.
Refer to the
instructions for the developer temperature,
replenishment rates and throughput speed.
The safety key must be removed during
normal working
inserted during maintenance and under the
responsibility of the operator involved.
After having carried out all the preparatory
operations, wait for the wording READY to
appear before actually inserting the plate. It is
in the meantime possible to feed a scrap plate
to test that everything is in working order.
USE: Insert the plate on the entry level and
push lightly until the first pair of rollers begins
to pull it.
When activated by the plate, the sensor
located beneath the entry level will allow a few
seconds to better position the plate, before
starting the processing cycle. As the plate
advances, the microprocessor will activate the
brush positioned inside the developer tank (if
installed), the gum pump, as well as the
washing and drying cycles in succession. It will
switch them off successively after the plate has
left the corresponding section.
Should a second plate be inserted whilst the
processor is already completing a work cycle,
the washing, gum and drying cycles will start
immediately and stop when the last plate is
inserted.
8
appropriate plate
operations
PROCESSOR USE
working
and only