Brother HL-S7000DN Service Manual page 420

1.4.13 EEPROM Dump Print (Function code 40)
<Function>
This function allows you to print the EEPROM logs described below.
<Operating procedure>
(1) Press the 4 and 0 buttons in this order in the initial state of the maintenance mode.
"E2PDUMP ENGN ALL" is displayed on the LCD.
(2) Press the
(3) Press the OK button. "E2DUMP PRINTING" is displayed on the LCD. The machine
starts to print the EEPROM log.
(4) Upon completion of EEPROM logs printing, the machine returns to the initial state of the
maintenance mode.
(5) If you press the Cancel button during printing, printing is interrupted and the machine
returns to the initial state of the maintenance mode.
LCD
E2PDUMP ENGN ALL
E2PDUMP MAIN TOP
E2PDUMP MAIN BTM
E2PDUMP MAIN ALL
or button to select the information you wish to print.
Print of all the values stored in the E2PROM of the engine control
unit. (print of 4 pages)
Print of the values stored in the E2PROM corresponding to the
top 1 Kbytes of the main controller. (print of 1 page)
Print of the values stored in the E2PROM corresponding to the
last 1 Kbytes of the main controller. (print of 1 page)
Print of all the values stored in the E2PROM of the main
controller. (print of 4 pages)
5-32
Description
Confidential