Advertisement
The battery needs charging or there is a bad connection to the battery.
1 LED
Check the connections to the battery. If the connections are good, try
charging the battery.
The left hand motor* has a bad connection. Check the connections to
2 LED
the left hand motor.
The left hand motor* has a short circuit to a battery connection. Contact
3 LED
your service agent.
The right hand motor* has a bad connection. Check the connections to
4 LED
the right hand motor.
The right hand motor* has a shirt circuit to a battery connection. Contact
5 LED
your service agent.
The wheelchair is being prevented from driving by an external signal.
6 LED
The exact cause will depend on the type of wheelchair you have, one
possibility is the battery charger is connected.
A joystick fault is indicated. Make sure that the joystick is in the center
7 LED
positon before switching on the control system.
A possible control system fault is indicated. Make sure that all connections
8 LED
are secure.
The parking brakes have a bad connection. Check the parking brake
9 LED
and motor connections. Make sure the control system connections are
secure.
An excessive voltage has been applied to the control system. This is usually
10 LED
caused by a poor batteryconnection. Check the battery connections.
A communication fault is indicated. Make sure that the joystick cable is
7 LED S
securely connected and notdamaged.
An Actuator trip is indicated. If more than one actuator is fitted, check
8 LED A
which actuator is not workingcorrectly. Check the actuator wiring.
Advertisement
