Advertisement
2
.
P
a
n
e
l
E
x
p
2
.
P
a
n
e
l
E
x
p
Status
LED
PoE (for
On (Green)
P2100)
Blinking (Green)
Off
On (Green)
RJ 45
LNK/ACT Port
On (Amber)
1 ~ 8
Blinking
Off
On (Green)
Port 9 ~ 10
SFP LNK/ACT
On (Amber)
Blinking
Off
On (Green)
SYS
Blinking (Green)
Off
On
PWR
Off
Interface
RJ 45 LNK/ACT Port 1 ~ 8
PoE for Port 1 ~ 8
Console
SFP LNK/ACT Port 9 ~ 10
RST
l
a
n
a
t
i
o
n
l
a
n
a
t
i
o
n
PoE for Port 1 to Port 8
RJ45 LNK/ACT
Port 1 to Port 8
Explanation
Devices connected over the PoE maximum power budget.
More than 80% of maximum power budget is supplied for PoE device(s).
Devices connected within the PoE maximum power budget.
The device is connected with 1000Mbps.
The device is connected with 10/100Mbps.
The system is sending or receiving data through the port.
The port is disconnected or the link is failed.
The device is connected with 1000Mbps.
The device is connected with 10/100Mbps.
The system is sending or receiving data through the port.
The port is disconnected or the link is failed.
The switch finishes system booting and the system is ready.
The switch is powered on and starts system booting.
The power is off or the system is not ready / malfunctioning.
The device is powered on.
The device is powered off.
Description
Port 1 to Port 8 can be used for Ethernet connection and PoE connection,
depending on the device connected.
Used to perform telnet command control.
Port 9 to Port 10 are used for fiber connection.
Factory reset button.
Press it to reboot the system. (<5 seconds) The PoE/Alert and SYS LEDs will
blink too.
Press it to reset the system with factory default settings. (5~20 seconds)
The PoE/Alert and SYS LEDs will be off if RST button is pressed between 5
seconds and 10 seconds.
Power inlet for AC input (100~240V/AC, 50/60Hz).
CONSOLE
2
SFP
LNK/ACT
Advertisement
