Advertisement
7.3.4
Configuring the Scroll Feature
7.3.5
Programming the Configuration Mode Screens
EPM 2200 MULTI-FUNCTION POWER METERING SYSTEM – USER GUIDE
4.
Push the DOWN Button to scroll all the parameters: scroll, CT, PT, connection
(
) and port.
Cnct
The active parameter is always flashing and displayed in the "A" screen.
Use the following procedure to configure the scroll feature.
1.
Press the ENTER button to display the
2.
Press the RIGHT button to change the display to
When in scroll mode, the unit scrolls each parameter for 7 seconds on and 1 second off.
The meter can be configured through software to only display selected screens. In this
case, it will only scroll the selected displays.
3.
Push ENTER to select
The screen scrolls to the CT parameters.
Use the following procedure to program the screen for configuration mode.
1.
Press the DOWN or RIGHT button (for example, from the
below) to display the password screen, if enabled in the software.
2.
Use the DOWN and RIGHT buttons to enter the correct password (refer to
Reset Mode on page 7–4 for steps on password entry).
CHAPTER 7: CONFIGURING THE METER USING THE FRONT PANEL
SCrL no
FIGURE 7–4: Scroll Mode Configuration
or
.
YES
no
message.
as shown below.
SCrL YES
message
Ct-n
7–7
Advertisement
