NAD C 298 Owner's Manual
  1. Manuals
  2. Brands
  3. NAD Manuals
  4. Amplifier
  5. C 298
  6. Owner's manual

NAD C 298 Owner's Manual

Stereo power amplifier
Hide thumbs Also See for C 298:
Table of Contents

Advertisement

Quick Links

C 298
®
Stereo Power Amplifier
© NAD C 298
Owner's Manual

Advertisement

Table of Contents
loading

Related Manuals for NAD C 298

Summary of Contents for NAD C 298

  • Page 1 C 298 ® Stereo Power Amplifier © NAD C 298 Owner’s Manual...

  • Page 2: Important Safety Instructions

    IMPORTANT SAFETY INSTRUCTIONS • Read instructions - All the safety and operating instructions should be read • Damage Requiring Service - Unplug this product from the wall outlet and refer before the product is operated. servicing to qualified service personnel under the following conditions: •...
  • Page 3 NAD is a trademark of NAD Electronics International, a division of Lenbrook Industries Limited Copyright 2020, NAD Electronics International, a division of Lenbrook Industries Limited...

  • Page 4: Getting Started

    Refer to the supplied C 298 Quick Setup Guide for basic instructions Please save the box and all of the packaging in which your C 298 arrived. in setting up your new NAD C 298. The following guidelines must be Should you move or otherwise need to transport your C 298, this is by far observed when setting up your C 298.

  • Page 5: Identification Of Controls

    IMPORTANT NOTES For the Standby button to activate, the following must occur: a The supplied power cord from the C 298 must be plugged in to a power source. b The rear panel POWER switch must be set to ON.

  • Page 6: Rear Panel

    ATTENTION! Please make sure that the C 298 is powered off or unplugged from the mains power source before making any connections. It is also advisable to power down or unplug all associated components while making or breaking any signal or AC power connections.
  • Page 7 • • This output will be 12V when the C 298 is ON and 0V when it is If you do not intend to use the C 298 for long periods of time (such either OFF or in standby mode.

  • Page 8: Audio Specifications

    REFERENCE SPECIFICATIONS All specs are measured according to IHF 202 CEA 490-AR-2008 standard. THD is measured using AP AUX 0025 passive filter and AES 17 active filter. AUDIO SPECIFICATIONS ANALOG AUDIO INPUT/LINE OUT THD (20 Hz – 20 kHz) <0.0005 % at 2V out Signal-to-Noise Ratio >120 dB (IHF;...
  • Page 10 All rights reserved. NAD and the NAD logo are trademarks of NAD Electronics International, a division of Lenbrook Industries Limited. No part of this publication may be reproduced, stored or transmitted in any form without the written permission of NAD Electronics International.

Table of Contents