2-10. Lens Assy Removal
• Remove the C Board (Refer to 2-5.).
4 Lens bracket
Remove the lens assembly attached
to the lens bracket instead of the single
lens assembly, if possible.
2-11. Prism Block Removal
• Remove the B and Q Boards (Refer to 2-6.).
• Remove the optical unit assy (Refer to 2-7.).
5 Polarizer, R-OUT plate
4 Prism block
NOTE: Use extreme care not to tuch the
glass section of prism, LCD and
conductive section of the flexible
cable in particular.
1 Four screws (+B3 x 8)
2 Lens bracket
3 Two screws (+B3 x 8)
2-6
5 Four screws (+PSW4 x 8)
6 Lens assy
3 Four screws (+B3 x 8)
6 Polarizer, G-OUT plate
7 Polarizer, B-OUT plate
1 Two screws (+B3 x 8)
2 Lens holder
!= Screw
![ Washer
9 Screw
!/ Washer
!- Polarizer, B-IN
plate
!] Polarizer, G-IN plate
8 Five screws
!\ Screw
!; Washer
!' Polarizer, B-IN plate
VPL-VW10HT