Sony VPL-VW10HT Service Manual page 17

Projecting
When the 16 : 9 picture is displayed on the
4 : 3 screen
Example: The 120 inch screen is used.
2,438
1,371
1,829
The 110 inch picture is displayed.
4:3 screen 16:9 picture
Size Size
Unit (mm) Unit (mm)
(Inch) (Inch)
80 73
1,626
1,626
1,219
100 91
2,032
2,032
1,524
120 110
2,438
2,438
1,829
Notes on changing the aspect
This projector provides you with the various choices
of aspects. When changing the aspect, check the
following:
• Select an aspect taking into account that one which
changes the aspect ratio of the original picture will
provide a different look from that of the original
image.
• Also note that if the projector is used for profit or for
public viewing, modifying the original picture by
switching aspects may constitute an infringement of
the rights of authors or producers which are legally
protected by laws.
20
(GB)
To turn off the power
To turn off the power from the control panel
1
Press the I / 1 key on the control panel.
"Power OFF?" appears on the screen.
Note
The message will disappear if you press any key
except the I / 1 key, or if you do not press any
key for five seconds.
2
Press the I / 1 key.
The ON/STANDBY indicator flashes in green and
the fan continues to run for about 120 seconds to
reduce the internal heat. Also, the ON/STANDBY
indicator flashes quickly for the first 40 seconds.
During this time, you will not be able to turn the
power back on with the I / 1 key.
3
Unplug the AC power cord from the wall outlet
after the fan stops running and the ON/STANDBY
indicator lights in red.
When you cannot confirm the on-screen
message
When you cannot confirm the on-screen message in a
certain condition, you can turn off the power by
holding the I / 1 key for about one second.
To turn off the power from the Remote
Commander
1
Press the 1 key on the Remote Commander.
2
Unplug the AC power cord from the wall outlet
after the fan stops running and the ON/STANDBY
indicator lights in red.
Note
Do not unplug the AC power cord while the
fan is still running; otherwise, the fan will
stop although the internal heat is still high,
leading to breakdown of the projector.
About the air filter cleaning
Clean the air filter every 300 hours to ensure
optimal performance.
Using the MENU
The projector is equipped with an on-screen menu for
making various adjustments and settings.
You can select the language for displaying in the
menu.
For details on the selecting the language used in the menu,
see page 17 (GB).
1
Press the MENU key.
The menu display appears.
The menu presently selected is shown as a yellow
button.
INPUT-A
PICTURE CTRL
CONTRAST: 80
BRIGHT: 50
RGB ENHANCER: 30
COLOR TEMP:LOW
2
Use the M or m key to select a menu, then press
the , or ENTER key.
The selected menu appears.
Menus Setting items
INPUT-A
SET SETTING
STATUS: ON
INPUT-A: COMPONENT
INPUT-B: COMPONENT
LANGUAGE: ENGLISH
POWER SAVING: OFF
SIRCS RECEIVER: FRONT&REAR
3
Select an item.
Use the M or m key to select the item, then press
the , or ENTER key.
4
Adjust an item.
• When changing the adjustment level:
To increase the number, press the M or , key.
To decrease the number, press the m or < key.
Press the ENTER key to restore the original
screen.
• When changing the setting:
Press the M or m key to change the setting.
Press the < or ENTER key to restore the
original screen.
For details on setting individual items, see the relevant
menu pages.
Using the MENU
To clear the menu display
Press the MENU key.
The menu display disappears automatically if no key
is pressed for one minute.
To reset items that have been adjusted
Press the RESET key.
"Complete!" appears on the screen and the settings
appearing on the screen will be reset to their factory
preset values.
Items which can be reset are:
• "CONTRAST", "BRIGHT", "COLOR", "HUE",
"SHARP" and "RGB ENHANCER" in the
PICTURE CTRL menu.
• "DOT PHASE", "SIZE H" and "SHIFT" in the
INPUT SETTING menu.
About the memory of the settings
The settings are automatically stored in the projector
memory.
When no signal is input
When there is no input signal, "NO INPUT–Cannot
adjust this item." appears on the screen, and each item
cannot be adjusted.
21
(GB)