Sony FDR-AX700 Service Manual page 22

2019/01/18 06:14:17 (GMT+09:00)
Self-diagnosis Code
Block
Function
C 1 3
C 1 3
C 1 3
C 1 3
C 3 2
C 3 2
E 2 0
E 3 1
E 4 1
E 4 1
E 4 1
E 6 1
E 6 1
E 6 1
*1: Start the Adjust Manual in the Adjust Station and execute the "Destination data write" on the ADJUST tab.
*2: Function of this code is not provided in this unit.
FDR-AX700
Symptom/State
Detailed
Code
0 1 Memory card is unformatted or
memory card is broken.
0 2 Access error
0 3 Access error (External media)
0 4 Abnormality of the drive (External
media)
0 1 Trouble with hardware
6 0 Difficult to adjust focus
(Cannot initialize focus)
0 0 Flash memory data are rewritten.
0 0 Abnormality of the drive
0 0 Abnormality of the wireless LAN
module or CPU
0 1 Abnormality of network control de-
vice
Wired Ethernet device error
1 0 *2
0 0 Difficult to adjust focus
(Cannot initialize focus)
1 0 Zoom operations fault
(Cannot initialize zoom lens)
1 1 Focus or zoom fault
Correction
Format the memory card.
Insert a new memory card.
Remove the power source. Reconnect it again and operate
the unit again.
Turn power off and turn power on again.
Turn power off and turn power on again.
Turn power off and turn power on again.
Turn power off and turn power on again. When this error is
not cleared, the focus control signal for the lens block may
be faulty.
Check whether this error is due to the lens or the board.
Replace the faulty lens or board.
Make flash memory data correct value.
Turn power off and turn power on again.
The peripheral circuit of between CPU and wireless LAN
module may be faulty.
Replace the board that contains this peripheral circuit.
Turn power off and turn power on again.
The peripheral circuit of between Wired Ethernet device
may be faulty.
Replace the board that contains this peripheral circuit.
Turn power off and turn power on again. When this error is
not cleared, the focus control signal for the lens block may
be faulty.
Check whether this error is due to the lens or the board.
Replace the faulty lens or board.
Turn power off and turn power on again. When this error is
not cleared, operate the zoom lever and check following
items.
• When zooming is performed, the zoom control signal
for the lens block may be faulty.
• When zooming is not performed, the zoom motor
drive circuit may be faulty.
Check whether this error is due to the lens or the board.
Replace the faulty lens or board.
Check both C: 32: 60 and E: 61: 10 of the self-diagnosis
code.
Sony CONFIDENTIAL
For Authorized Servicer
*1
Continued
1-2
SYS SET