Table of Contents
Advertisement
Chapter 2
Installation
Unpacking
Step
1
2
3
4
5
6
7
Super-Voyager LC Motherboard User's Guide
Action
Inspect the cardboard carton for obvious damage.
If damaged, call American Megatrends Technical
Support at 404-246-8600.
Leave the Super Voyager LC motherboard in its
original packing.
Perform all unpacking and installation procedures
on a ground-connected anti-static mat. The
operator should wear an anti-static wristband,
grounded at the same point as the anti-static mat.
Or use a sheet of conductive aluminum foil
grounded through a 1 megohm resistor instead of
the anti-static mat. Similarly, a strip of conductive
aluminum foil wrapped around the wrist and
grounded through a 1 megohm resistor serves the
same purpose.
Inside the carton, the Super Voyager LC
motherboard is packed in an anti-static bag, and
sandwiched between sheets of sponge. Remove
the sponge and remove the anti-static bag. Save
the original packing material in case of
reshipment.
Place the Super Voyager LC motherboard on a
grounded anti-static surface component-side up.
Inspect the motherboard for damage. Do not apply
power to the motherboard if it has been damaged.
Press down on all ICs mounted in sockets to verify
proper seating.
If the motherboard is undamaged, it is ready to be
installed.
Advertisement
Chapters
Table of Contents
