Reset Switch; Power Led Connector; Usb Connectors - American Megatrends Megathon User Manual

Step 8 Attach Cables,
USB Connectors USB0, USB1, J4 The USB (Universal Serial Bus) connectors, USB0 (bottom), and
USB1 (top) are used to link with peripheral devices. J4, a pinhead, is used to
connect USB devices on the front panel. The pinout is:
Button Board The block connector contains the following components:
Reset Switch Connector This is a two-pin berg that is attached via a cable to an externally-
mounted reset switch. When the reset switch is pressed, the system performs a
hard reset.
Power Switch Connector This is a two-pin berg that is attached via a cable to an externally-
mounted power switch.
Power LED Connector This is a two-pin connector that attaches to a cable that connects to the
hard disk LED mounted on the computer enclosure. The LED indicates data
transfers.
18 Megathon PCI Motherboard User's Guide
Continued
Cont'd