American Megatrends Baby Screamer LC User Manual page 19

S t e p 4 I n s t a l l t h e M o t h e r b o a r d , S t e p 4 I n s t a l l t h e M o t h e r b o a r d ,
Step
a
b
c
d
e
f
g
h
i
j
Baby Screamer LC Motherboard User's Guide
Place the chassis for the motherboard on an anti-static mat.
Connect the chassis to ground to avoid static damage during installation.
Connect an alligator clip with a wire lead to any unpainted part of the chassis.
Ground the other end of the lead at the same point as the mat and the
wristband.
Rotate the chassis so that the front is to the right, and the rear is to the left.
The power supply is mounted at the far end of the chassis.
Push four nylon standoffs from the solder side of the motherboard in the
holes provided for them. The standoffs lock in place.
Find the slots provided for the standoffs on the chassis.
Hold the motherboard, component -side up, with the edge with three standoffs
toward the front, and the edge with the power supply connector away from
you. The edge connectors for the adapter cards are on the left.
Carefully slide the motherboard into the chassis. Make certain that the
standoffs fit the slots provided for them. If the standoffs are properly
locked, the motherboard should not slide. It should also rest level with the
chassis. The far edge should fit the slots in the plastic clips.
Place the two mounting screws in the holes provided for them and tighten
them. If necessary, shift the motherboard slightly to align the mounting holes
on the motherboard with the holes on the chassis.
Continued
Action
15