Starting The Pressure Washer - Westinghouse WPX2700 User Manual

OPERATION

STARTING THE PRESSURE WASHER

BEFORE STARTING THE PRESSURE
WASHER REVIEW THE SAFETY SECTION
STARTING ON PAGE 5.
NOTICE
Pressure washer may walk or move when used on
hard surfaces. Be sure the unit is secure during
operation.
The pump is equipped a with a thermo valve. If the
pump is run for an extended period of time without
water flowing through it, it could overheat. If the
pump gets to a certain temperature, the thermo valve
will open and discharge warm water out the valve to
allow cold water in to cool the pump.
Before attempting to start the pressure washer, verify the
following:
• The engine is filled with engine oil (see Initial Oil Fill).
• The pressure washer is situated in a proper location
(see Location Selection)
DANGER
Never operate the pressure washer
in an enclosed area. Engine exhaust
contains carbon monoxide that can
kill in minutes. Only operate the
pressure washer outside and away from
windows, doors and vents.
1. Move pressure washer to a flat surface outside in a
well ventilated area. Maintain 5ft distance from any
surrounding buildings.
2. Check oil levels.
3. Flip the trigger lock lever up and lock the trigger in
the OFF position.
4. Make sure the water supply is turned on.
5. Point the thermo valve away from the work area you
are washing to avoid being sprayed with warm water.
6. Move the engine ON/OFF switch to the ON position.
7. Move the choke lever to the CHOKE position.
CHOKE
8. Slide the fuel valve to the ON position
OFF
9. Firmly grasp and pull the starter handle slowly until
you feel increased resistance. At this point, apply a
rapid pull on the starter handle.
NOTE: If the engine starts briefly and then shuts off,
squeeze the trigger on the spray gun to relieve the
pressure before trying to start the engine again.
10. Once the engine starts, move the choke lever to the
RUN position. Allow the engine to warm up slightly
before beginning washing.
CHOKE
Westinghouse Outdoor Power Equipment | 13
RUN
ON
RUN