Safety Instructions - Dometic PERFECTROOF Installation Manual

PR2000, PR2500
2

Safety instructions

Please observe the prescribed safety instructions and stipulations from the
vehicle manufacturer and service workshops.
!
WARNING! Failure to obey these warnings could result in death
or serious injury.
Electrocution hazard
• Ensure that the awning has been installed by a qualified technician in
accordance with the Dometic installation manual.
• Only motor version: If connection cable of the awning is damaged,
it must be replaced by the manufacturer, service agent or a similarly
qualified person in order to prevent safety hazards.
Health hazard
• Keep a sufficient distance from objects or other vehicles. Once it is
retracted, it should be at least 40 cm away from other objects and
vehicles.
• If the installation position is not predefined by the mounting rail,
ensure the roof of the motorhome can safely take the weight of the
awning before installation. Otherwise, the awning may become
unstable and bend or break.
A
NOTICE!
• If the vehicle-specific installation manual specifies through bolting,
ensure the inner screw joints are accessible.
• If there is insufficient space above the door after the awning is
mounted, the door must remained closed when retracting or
extending to avoid the door making contact with the arms or the front
panel.
The required space depends on the design of the door (door width,
swing or sliding door) as well as the set awning angle of inclination
(fig. 2, page 4).
• The cables and cabinets in the interior of the vehicle may not be
damaged by drilling the holes.
I
NOTE
• Ensure the user of the vehicle is aware that the screws on the rear hinge
(fig. 3, page 4) must be tightened up (see operating manual). The
arms must not bear any load. This must be done by a service agent.
EN
Safety instructions
11