Positioning; Window Foam Fitting; Permanent Wall Fitting; Important - Amcor AF 8000E User Manual

GB

POSITIONING

This unit can easily be moved from one room to another. In doing so keep this in
mind:
• The air conditioner must stand upright on an even surface.
• Do not position near bath, douche or other permanent wet or damp area.
• Keep for free air circulation at least 50 cm free from any obstacle or curtains.
1

Window foam fitting

If necessary, cut the foam to the height or width of the window.
• Pass the adapter (11) through the opening in the foam (16) and put the exhaust
hose (12) into the hose adapter (11) (fig. 1).
• Place the foam with the hole (16) – if needed together with the foam
extension (15) – in the window and close this as far as possible to refrain the
warm air from re-entering the room.
Depending on how the window opens, vertically (fig. 2a) or horizontally (fig. 2b).
• Connect the exhaust hose to the air conditioner (fig. 3a).

Permanent wall fitting

Make sure that no pipes or wires run through the chosen spot.
• Drill a hole to fit the outer diameter of the adapter (11).
• Connect the exhaust hose (12) to the air conditioner (fig. 3a).
• Connect the exhaust hose to the adapter (fig. 3b).
• Place the adapter with hose in the hole (fig. 4) and fix with plugs and screws.
Use the cap (10) to close the hole when the air conditioner is not placed (fig. 5).

Important

The flexible exhaust hose can be extended from 300 to 1500 mm for mounting.
This length has been designed especially according to the specifications of the air
conditioner. Do not use an extension or exchange for a different hose as that may
lead to malfunctioning.
The exhaust air must flow freely, any blockage can lead to overheating of the air
conditioner. Take care to prevent any kink or bend in the exhaust hose.
6
a
2
3 a
b 3 b
2
4
5