Tuning Analogue Television Stations - Grundig 19 VLC 2001 C Manual

SPECIAL­SETTINGS
Tuning­analogue­television­sta-
tions
This setting is only necessary if you cannot re-
ceive any digital stations and you have not car-
ried out an analogue search during initial setup.
The television station can be set directly or using
the search.
Switching­the­television­to­ana-
logue­channels
1 Open the »INPUT SOURCE« menu by press-
ing » «.
2 Select input source »ATV« with »
and press »OK« to confirm.
Note:
Additional operations are explained in the
7
following sections.
Re-tuning­all­analogue­television­
channels
These settings are only necessary if you can not
receive any digital stations or if you want to re-
tune all analogue channels.
The analogue television stations are listed in the
channel list after the digital television stations.
Note:
Plug the rooftop antenna cable (for ana-
7
logue television stations) into the »ANT­IN«
socket on the television.
1 Open the menu with »M«.
– T he »PICTURE« menu appears.
2 Select the »CHANNEL SETUP« menu with
» « or » «.
r e
3 Select »Autotuning« with »
confirm with »OK«.
4 Select »Country Selection« by pressing »
or » « and press »
w r
setting.
5 Select the »Scan Type« with »
Press » « or » « to select the »ATV« display
r e
and start the search with »OK«.
­-----------------------------------------------------------------------------------------------------
« or » «
q w
« or » « and
q w
q
« or » « to make the
e
«.
q
– T he »Searching...« menu appears, and the
search for analogue TV stations begins. This
may take several minutes depending on the
number of television stations received.
Note:
You can stop the search by pressing »M«.
7
6 Press »M« to end the setting.
Tuning­the­analogue­television­
channels­by­entering­the­channel­
numbers
1 Open the menu with »M«.
– T he »PICTURE« menu appears.
2 Select the »CHANNEL SETUP« menu with
» « or » «.
r e
3 Select »Analogue Manual Tuning« with »
or » « and press »OK« to confirm.
w
Analogue Manual Tuning
System
Current Channel
Fine Tuning
Search
Programme No
Skip
Frequency
4 Select the »Programme No« by pressing »
or » « and press »
w
5 Select »Current Channel« with »
6 Press »OK« to choose between »S« (special
channel) or »C« (channel).
7 Enter the channel number with »
step by step or with »1...0« directly.
«
Note:
The current system is displayed in the »Sys-
7
tem« line. If the colour and/or sound is not
functioning correctly, select »System« with
» « or »
q
with » « or »
r
8 Press »●« (red) to finish the setting.
BG
S 21
+ 00
a s
a s
1
Yes
443.25 MHz
Save
Select
Back
Exit
« or » « to set the preset.
r e
q
r
«. Select the necessary settings
w
«.
e
ENGLISH
«
q
«
q
« or » «.
w
« or » «
e
39­