Wireless Remote Control - LG LW1216HR Owner's Manual

16 OPERATION
Filter Reset
6
The Clean Filter LED lights up to notify you
control panel to turn off the Clean Filter light.
NOTE
●
control panel, not the remote control.
● This feature is a reminder to clean the air
light turns on after 250 hours of operation.
Temperature Control
7
The thermostat monitors room temperature
to maintain the desired temperature. The
thermostat can be set between 60 °F–86 °F
(16 °C–30 °C). Press
increase or decrease temperature setting.
NOTE
● A slight heat odor may come from the unit
when first switching to HEAT after the cooling
season is over. This odor, caused by fine dust
particles on the heater, will dissipate quickly.
● Auto Restart: If the
air conditioner turns off due
to a power outage, it will restart automatically
once the power is restored, with the same
settings as were set before the unit turned off.
● Energy Saver: The unit defaults to the Energy
Saver mode each time the unit is switched on
except in Fan mode or when power is restored
after an electrical power outage.
● The remote control will not function properly if
the AC infrared sensor is exposed to direct light
or if there are obstacles between the remote
control and the air conditioner.

Wireless Remote Control

Inserting Battery
Filter Reset on the
1
2
or arrows to
3
NOTE
● One new battery is supplied with the air
conditioner for use in the remote control.
● Do not use a rechargeable battery. Make sure
that the battery is new.
● In order to prevent discharge, remove the
battery from the remote control if the air
conditioner is not going to be used for an
extended period of time.
● Keep the remote control away from extremely
hot or humid places.
● To maintain optimal operation of the remote
control, the remote sensor should not be
exposed to direct sunlight.
Push out the cover on the back of the
remote control with your thumb.
With the plus and minus poles facing as
marked, insert one new AAA 1.5 V
battery.
Reattach the cover.